I noticed 3 of the 4 engine mounts are shut (separated) on my 09 Grizzly 700, with 6500km on the clock.
Now, i did alot of searching, refered to the service manual, but there doesnt seem to be a clear way of doing it, so i’m asking if anybody has imput on this matter.. From what i figured;
*Move front and rear diff in order to clear and remove front and rear driveshafts
*Remove exhaust
*Remove shift linkage
*Drain coolant and remove water pump inlet tube in order to clear mount bolt (F/L)
*Remove clutch primary and secondary sheaves in order to remove inside cover to clear access to bolt (F/R)
…Anything else?
My plan is to lift the engine up 1-2 inches in order to clear the mounts and replace them with the engine in the bay.
Any imput?
Thank you guys!
