While I was wiring my winch up the other day I had my skid plate off on my 900S. I noticed that the bottom side of my gas tank looked caved in. Mostly around where the driveshaft goes through. Was a little more closer to the passenger side that just didn’t look right. I have no damage to the skid plate indicating I bottomed out on something to have caved it in. Not to mention I would have probably busted radiator lines if I had. My question is the 900S gas tank molded that bad. Its like their is no design to the design for lack of better terms to describe it. Could anyone post pictures of the bottom of theirs so I can get an idea if mine is not right. Or could you answer that this is normal on mine and it was molded that way for clearance around driveshaft, radiator lines, and etc…. Thanks for any input in advance!