Hey guys just hit the 2000 mile mark on my 2014, and I’m starting to notice some clunking in the front end from the a-arm bushings, so here’s my questions. What all are you guys doing when you replace the bushings? Are you replacing the ball joints, bearings, tie rod ends, and shock bushings at the same time? Also what about the rears, should I redo the rear at the same time so everything is fresh? I haven’t noticed any play from the rear, but I wasn’t sure. Going to do the brake pads also. I’ve seen that everyone recommends either utv inc or super daves for the bushings, but after 2000 miles I’ve seemed to have pretty good luck with oem stuff. I know if I order all that through Superdaves it’s $795, not sure on oem yet.