Hello everyone, I’m new to the forum and I’ve searched everywhere for an answer to this so if it was posted and answered before I apologize. I have a 2004 Honda Foreman 450 ES, the front brakes won’t hold pressure. I’ve replaced the master cylinder, and both slave cylinders, bleed the brakes, and adjusted them, spinning all 4 adjusters until tight then backing off 1/4 turn and they still won’t hold. If I pump them a couple of times, the will get tight and stay that way, but after not applying pressure for a few seconds all pressure has been lost. If anyone could help I would greatly appreciate it. Also on a side note, if anyone knows how to remove the rear cam for the rear brakes and clean and re grease it I would greatly appreciate that input as well. Thanks ahead of time guys.