Hi I’m in the proscess of installing throttle bodies off xp1k I have pretty much got it wrapped up as far as the install goes now I’m to the hard part I assume that the map sensor on the top of the 900s pleum plugs into the map sensor on the side of the 1k TB correct? Or is that the tbsp? I had to make my own pleum out of aluminum sheet metal I didn’t my good friend owns a hot rod shop and he made me a sheet metal pleum!! So now im stuck im not sure how to plug in the TB motor that controls the throttle body blades cause the plugs are different on the 900s vs the 1ks also I should be able to adjust the fuel with a fuel controller to get the right afr correct. I do have BMP tune on the machine with the bully dog programmer. I know Nate from Alba and BMP have been testing these and I was just wondering if you guys could give me a bit of info on how your set ups are working and how to wire it up so the throttle bodies blades work.
Also I would post pics but I’m using an iPad and can’t figure out how to get pics on hear help with that would be great to!!!!
Thanks so much Geoff