Double Down Review

I got my Double Down installed Friday night and got to test it out Saturday a bit..

Installation:

The install was pretty easy and quick. Didn’t measure on the air box lid for the holes, just put the cylinders on the corners where they laid flat and marked the center. When it came to the box of the bed, I used the measurements given. I am a little confused with the seal kit. I got the black gasket in on the main air box, but the lid gasket (red gasket) seemed to be too small and not sure how to install it. Also the outer wear screens I was not sure where to install those.

Noise:

At idle I did not notice any difference in noise. From 0-20, I notice noise. Throaty grumble. not loud, just noticeable. I love the sound of it. from about 30 and up you it sounds like there is an exhaust in the cab, but its just the tubes sucking air. Little different from what I was used to, but after some time riding, I got used to it and liked the noise it made. Still would be able to talk over it and hear music over it.

Performance:

The biggest gains I noticed was from 40 mph to 60 mph. This thing pulled hard from 40-60 and was there in no time. I did have a new Gates belt on, so im not sure if it was the belt or intake, and was a fresh top end. Never tried hitting top speed.

Stopping Dirt. I sprayed some air filter sticky stuff on the foam pre filter that that comes with the kit, and checked my air filter after the ride. The pre foam filter was very dirty, and the stock paper filter was pretty good. Wasn’t bright white like new but didn’t seem to have sand falling out of it.

I like the kit so far. Just want to figure out how to install the outter wears and the red gasket. I hope it keeps dirt out of the motor and my air filters a little cleaner. I have only had it on one ride. Didn’t run my rzr very hard tho.

Question tho, with the foam pre filter, can I unsnap the foam from the plastic and wash it?? do you sell a replacement foam pre filter?