Recently bought an old 98 grizzly 600. Serious electrical issues but after pulling half my hair out I seem to have corrected them all. BTW I’m not a bad car mechanic but this is my first atv and they really are a science of their own. Pulled it out of the garage proud as a peacock only to be met with this curious new problem. Symptoms are; When I pulled away it felt like a brake was stuck and holding me back. I decided to proceed and see if it would go away but instead it got much worse to a point of like i was tied to a tree and the bike died. I waited about 2 minutes fired it up and i was able to advance only very slowly at high RPMs but got back to my garage. it also resembled a slipping clutch ( a bit) BTW the brake isn’t stuck as I can push it easily. I’ve been doing my research on the clutch and drive system but I can’t see how it could produce these symptoms. Any ideas would be greatly appreciated and solutions would raise you to god status. Also as a result I gathered some decent wiring diagrams so if that can be of any hep to anyone just let me know.
Cheers