Thought I would post some pictures of my back CVT cover nut insert reinforcement project. The 1st picture shows the size of drill bit next to the plastic hump that the nut insert is in. The next 2 pictures are the holes that I drilled in the plastic/nut insert that had spun on me. I drilled 3 holes in the one that spun, but I only drilled a single hole in the others (picture #4). After drilling the holes (I did drill into the nut threads) I put a bolt in the nut insert and then added the epoxy and needle bearing. Picture #5 is the epoxy that I used and you can see a couple of the needle bearing on the right side.
