While helping a friend replace the front left outer cv boot we’ve run into a problem… We are not set up with enough room to remove the axle. So we’ve seen the CONE method and have a long funnel cut to fit perfect , the problem is the cv boot is quite tough, thick rubber . I’ll give it a try tomorrow with the heat gun and dish soap as lube . I’d like to know if alot of HEAT will disfigure the cv boot ?? Or how hot can I get it before I ruin it ?? I’m trying to avoid ordering another cv boot . Is there a special trick in stretching the small hole of the cv boot over the large part of the axle ?? Again we do not want to remove the axle …