Custom mount for TrailTech Endurance II

I bought an Endurance II gauge for my quad… I liked everything about it except the mount they provided. They supply two handlebar clamps (different diameters), but they pretty much have to be on a horizontal section of the bar, and you have to hope that the resulting position of the gauge doesn’t interfere with cabling, controls etc.

I fiddled around quite a bit but there really didn’t seem like a good position for it, so I made my own.

I took a few measurements on the quad and the gauge, spent a few minutes on my computer and came up with this:

Click the image to open in full size.

Click the image to open in full size.

It attaches to the top of the dash-panel with automotive double-stick tape:
Click the image to open in full size.

I’ve tweaked the design a bit since those photos… the saddle angle is a closer fit to the dash-panel.

The mounting position is great… very visible and somewhat protected in the event of a roll-over. Time well tell if the mounting tape holds up. If it looks to be an issue, I can always use a couple bolts and lock-nuts to hold it in place.

Attached Thumbnails

Click image for larger version

Name:	IMG_2241-small.jpg
Views:	N/A
Size:	195.4 KB
ID:	24645
 

Click image for larger version

Name:	IMG_2245-small.jpg
Views:	N/A
Size:	86.5 KB
ID:	24646
 

Click image for larger version

Name:	IMG_2240-small.jpg
Views:	N/A
Size:	192.8 KB
ID:	24647