Category Archives: Wheels and Tires
tire monitor system?
I am planning to buy this one which is a Toyota one. but have the doubt of how many psi can read when at the lowest air level, that because regular cars uses 32 psi…. and rzr… from 8 to 20 psi….
tire monitor system?
I am planning to buy this one which is a Toyota one. but have the doubt of how many psi can read when at the lowest air level, that because regular cars uses 32 psi…. and rzr… from 8 to 20 psi….
WTB two 30x10x14 mongrels
92808
Thanks
WTB two 30x10x14 mongrels
92808
Thanks
OMF billit center series in the sand
Time for tires…
Any real knowledgeable tire guys here abouts?
I love the comments and suggestions for the regular joe rides like myself. But would be interested to hear for someone more knowledgeable in these things…
I was pretty set on just buying Maxis Big Horn’s again as I loved them on my Sportsman… But the RZR is bigger and heavier. So maybe a UTX spec, 8-10 ply would be better… but what to buy??
I like the looks of the BLK Waters, but hear that they wear terribly… and at one of the highest costing tires this is troublesome.
Rockthanes are a good possibility too, But for sizing…
See I LIKE my 12" factory rims and would like to keep them. IMHO they are tailor made to my needs with the offset and width made for the skinnier tires I want.
I would ideally like a 28x9x12, but no one makes one. I require a Radial tire. I don’t want a mud tire, I don’t do mud, I trail ride.
What is the real world difference between the STD Big Horn in 27x9x12 and the X2 28x10x12 Bighorn tires? I know the BH run large or truer to size. My factory are labeled 26" but my buddys wifes Yammi has factory maxis tires in 25 that are taller…
Will I see a difference with only a 6ply compared to a 8 or 10 ply radial?
Also, I will be replacing the POS factory springs and I really like what I am reading with the Keel Clickers claim to have ELIMINATED belt slipping… So may spring for one of there clutch kits if the can figure our t the spacer problem.
SO, I may be able to go even a bit taller and open up my selections farther. I find most makers stop at 27" in a 12" rim. I understand its allot of side wall. I just cant see wasting my $$ on new rims when I like mine and they are just fine.
HELP!
CW
GMZ Kahuna vs Pro Armor Crawler XG
Stones in the Wheel
STU’s for XP 1000, what wheels?
I was thinking 14×7, 13/5+2 for the front and some 14×10, -2/4+4 for the rears?
Method makes them but I would have to drill out the rears somehow since they are not available in the 1×156 pattern.
I really don’t know though, will they be wide enough? Should I get something else? I don’t have 2k to spend on just rims.
Planning on tributes up front and not sure which STU’s for the rear. These will be for hardcore dunning in Glamis but not for racing the hill, agility over top speed is what I’ looking for.