Have a 2012 XP, battery went low, recharged and now for some reason the gear selection display doesn’t show in the cluster, just dotted lines neither does rpm. Anyone ran into this issue before ? before I start looking into it
Thanks

Recently replaced front OEM wheel bearings on XP after 2,000 miles (totally worn out) with SuperATV WB-002 Wheel Bearings. Retorqued everything back to spec… went for a 50 mile ride and bearings are just as loose as they were before?

I think most of the wheel bearing movement is between the inner race of the bearing and the hub. The hubs show no signs of wear, just seen to be too undersized?

Is it ok for wheel to be that loose? Do I need new hubs? What do you guys think?

Has anyone used the 4500lb winch and mount plate they offer? It looks like a wide spool and it holds 50 ft of line. most of what I read says the wide ones wont work. they are priced pretty good.

Looking for a set of rear fender graphics for my xp, bought it with graphics removed which I like but the black over the fenders is discolored. I like the simple graphics on the stealth xp’s but would like for them to be outlined in orange. Anyone know where I can find a set or someone that could make some?
Thanks – mike

Attached Thumbnails

 

so my cooling fan went out on 2014 rzr900 xp before i buy a new one, does anyone have any input on better fans or improved cooling ideas. just like to see what options are out there ?

i have read a few post from doing a search? my rzr 900 xp has sat for about 7 months in my shop , i checked everything over and went for a ride today, nothing hard about 10min total ride time , when i pulled back in my shop i let idle for a bit and the overheat light came on? nothing has been moded or messed with so could this just be AIR from setting so long ?

Who run ripp tied clutches from boondocker with fuel custom covers? Is it fit or not?

Who run ripp tied clutches from boondocker with fuel custom covers? Is it fit or not?

Picked up a 13′ xp a couple months ago with a radius cage. I kept the speakers outta my 800 now can’t decide where to put them. I was wanting to make custom enclosures for the roof but can’t tell if the speakers will be too low. I have 2 6×9’s and 2 6.5’s. I’m needing suggestions on where/how to mount them or pictures of custom enclosures on aftermarket cage roof, thanks – mike

Picked up a 13′ xp a couple months ago with a radius cage. I kept the speakers outta my 800 now can’t decide where to put them. I was wanting to make custom enclosures for the roof but can’t tell if the speakers will be too low. I have 2 6×9’s and 2 6.5’s. I’m needing suggestions on where/how to mount them or pictures of custom enclosures on aftermarket cage roof, thanks – mike