Went to the dunes last weekend and they were abnormally rough. I noticed my suspension is really getting loud (squeaking). I assume this is coming from all the non-grease fitting points of movement? I plan on taking everything that moves and doesn’t have a grease fitting apart and put some grease on the bolts? Just wanted to post and see what everyone else is doing for a fix?

Attached Thumbnails

 

I have had several (like most of us) lighted whips by a couple different vendors.
Looking for goods and bads between safeglo, tribal, outlaw, gorilla etc. I am most concerned with strength to not snap on the first couple trips…. I am mounting a 4ft on my cage tabs-

I have had several (like most of us) lighted whips by a couple different vendors.
Looking for goods and bads between safeglo, tribal, outlaw, gorilla etc. I am most concerned with strength to not snap on the first couple trips…. I am mounting a 4ft on my cage tabs-

Anyone install or have riden a Reflex+8 System? They look pretty neat and Boost’n and Roost’n had a killer discount for Labor Day.

My 2015 rubbed a hole in the fuel line then caught on fire. Saved the razor. Has anyone had this problem? It has about 300 miles on it.

We just bought a RZR 4 1K, and of course heads are spinning with all the necessary (as far as we’re concerned!) upgrades…needing to get harnesses installed and not liking that low bar position behind the front seats. Checked the forum but haven’t found anyone who’s mentioned using the Dragonfire harness bar clamps as opposed to a harness bar. Anyone actually tried them?

Shaft Reverse 27T (stock is 29t)
323580
Shaft,Front ,output
3235631
Gear,46TStage 2 (Stock is 44T)
3235381
Sprocket,48T
3235632
Chain, silent
3235633

These are apparently the part numbers to "upgrade" your stock transmission to the Highlifter specs.

I installed this gear set in my 2014 XP4 1000, and got ZERO gear reduction.
In fact I now have a 2 mph HIGHER TOP SPEED than I did with the stock gears. (GPS TESTED)

Turner Cycle told me that their 32" gear reduction was the same ratio as the Highlifter. They also told me that their 32" gear reduction is a lower gear than the xp4 1000.

Something does not add up here.

Has anyone received the new red primary spring from Heel clicker? Just got mine and was wondering how it performs and if it’s worth putting in. thanks

and having these custom graphics made for it.

Man this hood looks bad ass…

??? Can I run a 28" sti sand slinger with my stock 29" bighorn fronts in the sand or will it tear stuff up? I know in 2-wheel drive it should be fine but how about in 4-wheel drive? Thanks!