Hey guys! I picked up my Fox Edition this weekend and had a question on what everybody is running their suspension at for a baseline. The rear’s seem like they have a ton of pre-load on the spring and the rear end is pretty darn stiff. Any input would be greatly appreciated!

While riding in the field I noticed a clanking noise some where underneath the seat.it only happens when the suspension is working or its in a corner. 2015 with less than 15 hours. any thoughts to where to start would be appreciated

Check the timing its right on compression 215 both cylinders
any one out there had this problem it does it only when cold

Check the timing its right on compression 215 both cylinders
any one out there had this problem it does it only when cold

This forum is loaded with awesome information! Thank you all for sharing your ideas and helping us new people get going. I’ve lurked for a few months, and this will be my first post!

This RZR is so fun, I can only imagine what would have happened if this was around 20 years ago when I was a "kid" 🙂 Most likely I wouldn’t be here to type this.

Anyways, we were out riding the other day after a lot of rain and hit a hole that was a tad deeper than expected and I think I pulled some water into the clutch case and the belt started slipping. I smoked her up good. After getting back up onto dry land, I stopped and looked it over, I opened the drain plug and only a few drops of water came out. Which leads me to my question, I see plenty of snorkel kits around, and a few have been discussed on here. Do any of you with a kit installed have feedback on your currently installed kit? I think I have narrowed my search down to 2 kits. The EAS one that comes with a blower fan, or the 3" kit from mudindustries.

I do not like how much cutting I have to do for the EAS to fit. The mudindustries claims minimal trimming for installation. Huge benefit imo. Is the fan that big of a deal?

I really appreciate any comments, and feedback you guys can offer!

Chopped my cage 6" and added the SuperATV 7-10" lift. I love it. It won’t let me upload 2 pictures for some reason so here is the before… After is below

Attached Thumbnails

 

Looking for a pic of a rzr with the red two tone utvinc grill ideally. May even consider the one with the light bar mount. Would like to see a better view of how it will look on the rzr (zoomed out a bit). Would be better if it was a black rzr, but will trake what I can get. Need to convince the wife I REALLY NEED ONE OF THESE

Thanks

Has anyone done this and how did you do it?

One of the places I ride there are a few small lakes. I would love to bring the kayak with me and paddle around on the lake. Any ideas or sujestions would be great. If you know how to fit 2 at the same time that would be great!

any problems with 29.5" High Lifter Outlaw II Mud Tires on stock 2014 rzr 1000. they are taken off the highlifter

I plan on installing a set of Assault High Clearance radius rods later today. I was looking at the service manual and it says to discard all the nuts after removing old rods and use new nuts. What is the opinion out there on this. I have not driven my 1000 except when picking it up and into the garage. Been busy customizing.