Who has installed the super atv full plastic doors on their 1000 and what is your opinion on them. Looking for how they line up and if you are happy with them

Out on the trail and broke a belt we rolled the primary backwards (by hand) to unjam the new belt and something went crunch.

Engine won’t start now. I’m guessing the timing chain or something broke?

How much travel does the kit have versus stock. Since its wider it should be a longer travel as well unless I’m seeing something wrong?

Is there a inner rod end by the steering rack under the boot? Doesn’t show any thing on parts fische but I have a lot of play there and was wondering if you can get the parts separate from a complete rack?

Anyone know where the clear vacuum lines run from and to, on the rear on the 2015? Had it the shop for trans repair and i think they ran the line wrong. Mine goes from the fuel pump area ends up around the air filter area. Looked at one at the dealer their’s run from the fuel pump area around to the passenger side valve cover to a fitting. Mine was built 7/14.

just finished making hear for myself. I was searching the net for a while looking for a good substitute but didn’t find anything that really struck me.

I will be looking into making a high clearance set and using different Heims with zerk fittings after I give these a run. They come in at 60% lighter and 180% stronger than their steel equivalent

Attached Thumbnails

 

Looking in to getting a turbo kit, whats best kit out there.

who’s running what, is it worth it to fab up your own set up?

thanks

I got stuck Saturday night and while being winched out, I noticed that my front wheels were still pulling even though it was in 2wd. Now even if 2wd is selected if I gas it in the mud and stay on it the front locks and starts pulling again. Any ideas?

Sent from my SM-N900V using Tapatalk

Want to get input and opinions on which direction I should go to protect the side/under of my XP1K… Anybody have the flush polaris rock sliders? Polaris rock nerf bars? Any other brands from other vendors work good?

Heading to Moab in a couple weeks and want to make sure my machine is protected… Thanks

My rear diff is leaking around rear axle. Pulled axle seal looks ok anyone know how to change seal?. Also when you shake axle it moves a lot on diff end. And do I need new axle?. Are splines bad? Sorry for all questions I have searched. And thanks.