Can anyone tell me what size the fill and drain plugs are for the front and rear diffs?

Sent from my iPhone using Tapatalk

I finally installed my power steering and before wheel lock the unit acts like it looses power and cuts out. Also mine didn’t come with a speed sensor wire I thought I read that these had them?

I was wondering if anyone has tried the super atv a-arms vs stock. I bent my stock a-arm yesterday didnt know if i should go back to a factory one or aftermarket. Just was wondering everyones opinions.

i know this probably has been posted before but im too lazy to look,

whats everyone using to wash their rzr’s? i heard someone using tide powder i think… so just curious what takes the red stains out… i have SC1 and coverall once its clean to make it shine but looking for something that works better than automotive soap

Attached Thumbnails

 

I just took the side vents off and found a lot of dirt in there. Is there a way to keep the dirt out of there?
Thank you,
John

I just took the side vents off and found a lot of dirt in there. Is there a way to keep the dirt out of there?
Thank you,
John

While I was wiring my winch up the other day I had my skid plate off on my 900S. I noticed that the bottom side of my gas tank looked caved in. Mostly around where the driveshaft goes through. Was a little more closer to the passenger side that just didn’t look right. I have no damage to the skid plate indicating I bottomed out on something to have caved it in. Not to mention I would have probably busted radiator lines if I had. My question is the 900S gas tank molded that bad. Its like their is no design to the design for lack of better terms to describe it. Could anyone post pictures of the bottom of theirs so I can get an idea if mine is not right. Or could you answer that this is normal on mine and it was molded that way for clearance around driveshaft, radiator lines, and etc…. Thanks for any input in advance!

Debating on buying the racer tech 1.5" lift for my 900s, anybody do it yet and like it? Just want a little bit to compensate for the spring sag but don’t want to lose my ride. I don’t want to buy new springs right now so thought maybe the lift would help, let me know the pros and cons. Thanks

I noticed my rear sway bar seems to be shifting on the bushings. That does not seem right considering the purpose of the sway bar is add rigidity. Has anyone seen this before. Is it just a matter of tightening the flange nuts?

First picture is the right side when standing behind the rzr. Second picture is the left side when standing behind the rzr.

I noticed my rear sway bar seems to be shifting on the bushings. That does not seem right considering the purpose of the sway bar is add rigidity. Has anyone seen this before. Is it just a matter of tightening the flange nuts?

First picture is the right side when standing behind the rzr. Second picture is the left side when standing behind the rzr.