Ok guys just recently bought a 09 rzr 5inch. I put 27 itps, 2in coil spacers and 1in wheel spacers. I was looking at getting time of those lift for a little extra clearance . Would I have any kind of axle problems with either kit since I already habe a 2in spacer?
have an 800 xc and thinking about another set of wheels and tires so i can run 50 inch trails. ive read here that sti makes a 6 1 offset wheel that will keep me 50 inch question is what tire size will i use? if anybody is running the sti setup on your machine please chime in. dont want to make a 1000 dollar mistake. thanks. 14 inch wheels is what i want.
I have a 2013 rzr 800, just bought a triple x 3 person freestyle xl bench seat for it. since my intake is between the stock seats will this cause a problem and if so what are my options.
The output shaft seal ( the shaft on the gear box that goes to the front diff. )on my 2011 rzr 800 is leaking. Has anyone ever changed the seal themselves? Can it be done without removing the gearbox? Please help.
Well &@*^$##@#, ok thats out of the way. 2012 800 12.8 volts at battery, 12 .7 volts in to key switch, 12.7 volts coming out with key on. When I turn the switch on no power to cluster, lights, fuel pump. Nothing changes as far as lights, pump, etc. with switch on. Chassis relay? With the chassis relay out I get 12.6 on the bottom left pen/slot on the relay receiver, no volts on the other 3 pins.
Well &@*^$##@#, ok thats out of the way. 2012 800 12.8 volts at battery, 12 .7 volts in to key switch, 12.7 volts coming out with key on. When I turn the switch on no power to cluster, lights, fuel pump. Nothing changes as far as lights, pump, etc. with switch on. Chassis relay? With the chassis relay out I get 12.6 on the bottom left pen/slot on the relay receiver, no volts on the other 3 pins.
I’ve got a 2011 rzr 4 that i bought used, and the bike is throwing the cam phase code, but the only problem, is that there is no cam phase sensor on the engine. I know its supposed to be right above the oil filter.. The plug from the harness is just sitting there but there is no where for the sensor to go. The bike starts and runs and everything, just has a sputtering issue at around 3,000 rpm on take off. Any help is appreciated.