Have a 08 800 aftermarket turbo pushing 8pounds of boost blew the bottom end..thanks fellas
Category Archives: RZR 800 Specific Discussion
RZR 800 primary puller work on a Sportsman 800?
Does anyone know if a 2008-2010 primary clutch puller will work on a 2012 Sportsman 800? No guessing I need to know for sure please.
RZR 800 primary puller work on a Sportsman 800?
Does anyone know if a 2008-2010 primary clutch puller will work on a 2012 Sportsman 800? No guessing I need to know for sure please.
2008 rzr 800 clutch or belt problems
having trouble with my rzr feels like the clutch system is holding the rzr back at low speed after letting off the gas not free wheeling not sure if its the belt or the secondary clutch or is this normal
New seats
Will the new RZR 900 and 900s seats fit into the 09 RZR?
rzr 800 compatability with 900
So I am brand new to the rzr world, I have been stuck with my high HP arctic cats, but wife wanted rzr so I picked up a 08 800 for cheep and have started over hauling it like I do everything. My question is I found a guy with a 2013 rzr 900 with a high lifter 5" lift and 2 sets of gorilla axles for all the way around. So he is selling 8 A arms/control arm and 8 axles and the high lifter lift, will it fit on the 800 and will the axles fit. I have looked on Google and try ed to part number match but can not get a solid answer. Any help would be greatly appreciated
Winter
Getting ready for winter here in Western Montana. What’s the procedure for getting my RZR ready, I will be plowing with it this winter.
Winter
Getting ready for winter here in Western Montana. What’s the procedure for getting my RZR ready, I will be plowing with it this winter.
Any one opening their clutch housing
Just finished snorkeling my 2012 800s and decided to pull housing to reseal the back side….now this machine has never been open up Ive owned it since new…to my surprize I found a shop rag wraped in plastic in my clutch exhaust port
This was done at the factory the only way I found it was because I pulled the rubber coupler off…this will cause major over heating of the clutch belt
Just putting this out there to be fair warning
This was done at the factory the only way I found it was because I pulled the rubber coupler off…this will cause major over heating of the clutch belt
Just putting this out there to be fair warning
Front wheel bearing/hub lube question
I am trying to wrap up my front wheel bearing job and have a couple lube questions.
The factory bearings had lost some grease onto the aluminum hub through the split in the bearing race. That or the hubs were greased from the factory. The question is, should I apply some grease to the aluminum hub where the inner bearing race sits?
The splines were greasy from the factory too, but no mention in the manual. Do I regrease the splines?
