I’m picking up my new 900-4 today and was wondering the best way to secure it to my trailer. Trailer deck is 12′ long by 74" wide. I haul my ATV on it and have always just used a ratchet strap through the frame and snugged down the suspension. Now we’re talking almost double the size and weight with the rzr. I’ve got three D ring anchors on each side of the trailer and can add two more to the other rails if needed. Really can’t add anything to the floor since I haul other stuff for work that requires me to slide the pallets or skids on with a forklift from the rear. E-track or D-rings in the floor wouldn’t work.
Can I use a tire bonnet at an angle or must it draw straight down from the tires? What about lasso straps? They just don’t look that secure, but I’ve never used them before. I’ll have about 7" between the tires and trailer frame rails. Pic of my trailer is attached.
My buddy has a 2012 XP 900 4 seater that will not idle and eventually sputters and dies. We replaced the IAC and cleaned the ground cluster and no luck. If you unplug the IAC it runs fine but as soon as you plug it back in it starts cutting out. The new one is doing the same thing the old one did. It does cycle when you turn the machine off but sounds like it is struggling to do so. Anyone have any ideas before he burns this thing in the yard?
My buddy has a 2012 XP 900 4 seater that will not idle and eventually sputters and dies. We replaced the IAC and cleaned the ground cluster and no luck. If you unplug the IAC it runs fine but as soon as you plug it back in it starts cutting out. The new one is doing the same thing the old one did. It does cycle when you turn the machine off but sounds like it is struggling to do so. Anyone have any ideas before he burns this thing in the yard?
I am looking for a roll cage for the 2105 RZR 900 4 roll cage. I spoke with a gentleman at RZR XP 1000 4 Gravity Motorsports – Peoria, AZ 623-772-5581- Turbo EPS,RZR XP 1000 4 ROLL CAGE $2,200.00 who said he would build one but has yet to have anyone come in with the new model. He said he could custom build one but the only problem is i am in Georgia and he’s in Arizona. I need to find someone who wants one built that can take their machine to him and he can get the correct measurements etc. He said he could work a deal for multiple cages. I have another friend locally in georgia that wants one too. who wants a cage in arizona?????
Thinking hard about which setup I want to go with, either overhead unit or in-dash mount, and would like to see what others have done if possible.
Thanks folks!
Anybody know of a good spring set-up for the rear. I would really like the rear of my 900 4 to stop bucking so bad through little jumps.https://vimeo.com/144318547
