Are the gear ratios the same for the rear ends of the 250 Honda atvs 1989s and the 2000 Honda 300 4trac if you want to use one rear end to rebuild the other? Please HELP!!! Thanks: confused:

Are the gear ratios the same for the rear ends of the 250 Honda atvs 1989s and the 2000 Honda 300 4trac if you want to use one rear end to rebuild the other? Please HELP!!! Thanks: confused:

So I need to get a bearing for a kickstarter shaft on a cr80 and it is not in the parts schematic on OEM part sites. I would think it would be… I need to get one tonight and cant find one. Any ever had to order them someplace else? I working on getting this bike running for a guy that lost half the pieces on that side of the engine and he want me to order new stuff and get it running.

thanks for any help,

Pierce

I got a Honda 3 wheeler that runs fine but after a little bit of riding it will not start i will put a new spark plug and it will for a little bit. some help would be great

will a rear end pinion and ring gear from a 250 Honda atv work in a 300 Honda 4 trac atv rear end?

will a rear end pinion and ring gear from a 250 Honda atv work in a 300 Honda 4 trac atv rear end?

hi there, i bought a honda 400 about 4 years ago. it had a huayi carb on it . it started working bad a while ago and the guy i bought it from told me to take it back to princess auto where he bought it . they gave me a new one. this one has something on the bottom hooked to the fuel bowl with 2 wires coming out of it. Where do they go and what is it
Thanks "Chuck"

I have a 2006 honda 450er that as soon as you start it spits water out the overflow tube on bottom right side of motor. any ideas?

I have a 2006 honda 450er that as soon as you start it spits water out the overflow tube on bottom right side of motor. any ideas?

I am literally about to pull my hair out.

I am rebuilding the rear diff for my brother in laws machine thus replacing all of the bearings.
I had to use a three jaw puller to get the old pinion gear bearing off the pinion. Long story short I have now purchased 4 differential aftermarket kits (some have been returned or refunded) including old faithful all balls (because everywhere online was back ordered ). All 4 of the bearings (yes they are the correct ones because they have the SCO4A90N on them like the OEM) slide right on to the pinion bearing–I do not have to press them on.

Does this matter? Am I the only one that has ever had this problem?Would y’all use them or should I just wait for the OEM back ordered ones?