Ok so guys I’ve posted a few threads lately but I especially need your input on this. My 2013 rancher 420 is the at model (dual clutch tranny) and when I am going about 40 and press on the brakes hard it makes a noise in the tranny like it is trying to catch up in the gearing. It does this in both manual and auto. My dad’s teryx will make a similar noise when letting off the gas so I was just wondering if this was normal or something wrong with the dual clutch or my tranny? Thanks guys.

Is it necessary to replace the fuel filter on a 06 rincon 680? How hard is it to do?

hi all ..like the title says i have a 91 trx350d that wont shift up or down it stuck in 4th while driving …the shifter moves a little each way and there is some spring tention but it will not shift it seemed to be getting harder to shift befor it finally stuck i was just wondering anyone has had or heard of this problem..i have a service manual downloaded and was wondering if those pawls wear out? any help is great thanks in advance

New to the whole forum thing but I was riding my 4wheeler today, then parked it and installed my winch, about an hour later I when to crank it up and it would turn over but wouldn’t start, went over everything then opened the air box and had about 3 1/2 inches of gas sitting in it. Needle and seat stuck? Or what? Atv is a 05 honda rancher 400 at

New to the whole forum thing but I was riding my 4wheeler today, then parked it and installed my winch, about an hour later I when to crank it up and it would turn over but wouldn’t start, went over everything then opened the air box and had about 3 1/2 inches of gas sitting in it. Needle and seat stuck? Or what? Atv is a 05 honda rancher 400 at

Hey guys I got a 2001 honda 450 es and the steering shaft bearing i think that’s what it’s called? The bottom of the shaft anyways how do I replace it I need detailed instructions if possible thanks

Hey I just bought an 85 250 big red as a parts wheeler for my 86 250 big red. I need to switch the rear ends over but need help on how to. any help is appreciated.

Hey I just bought an 85 250 big red as a parts wheeler for my 86 250 big red. I need to switch the rear ends over but need help on how to. any help is appreciated.

First time posting here.
So I was riding my 97 Honda foreman 400 the other day and got stuck. I tried going into reverse and couldn’t. It was stuck in first gear so I drove it home in first and got looking on the forums. I tried adjusting the clutch with the locking nut and screw on the crank case. That did nothing. I took the crank case off and nothing was broken or out of place so I sealed it up and put some new oil in. Still won’t shift. I tried to ground the green/red wire to bypass the neutral safety switch to try starting it in gear and it wouldn’t start. I don’t know what would cause the no shift problem, a bad clutch? Something in the trans? Any help would be appreciated.

Hey guys its been a while that the axile squeaks. Thought it was the bearings since the seal was sort of messed with, but after the first 5 minutes of riding it stops completely. It only does this in forward not reverse. Any suggestions?