While riding my atv, if i use high beams and try to accelerate the machine bogs down.. . Any help will be appreciated

I have a Polaris xplorer 4×4 I think its a 2001 250 2 stroke air cooled. The 4×4 is not working all the time. I notice when I get up to high speed the light will turn off then come on again when I slow down. and when im going slow in a mud hole it works sometimes. it seems to always work in reverse. and if I get stuck in 2 wheel then put it in 4 wheel it works about 75% of the time. Any ideas? I saw a video a guy said it might be in the shifter. Im going to lift it up in the air tomorrow evening to test it

I have a Polaris xplorer 4×4 I think its a 2001 250 2 stroke air cooled. The 4×4 is not working all the time. I notice when I get up to high speed the light will turn off then come on again when I slow down. and when im going slow in a mud hole it works sometimes. it seems to always work in reverse. and if I get stuck in 2 wheel then put it in 4 wheel it works about 75% of the time. Any ideas? I saw a video a guy said it might be in the shifter. Im going to lift it up in the air tomorrow evening to test it

have a 1995 polaris xplorer 400, can,t get it into 4wd, can anybody tell me where to start looking fo the problem.

Hi, I have a 94 xplorer 400 with a bad transmission. I came across a 96 scrambler with a seized motor. I was wondering if anyone knew if they would interchange? Any help is appreciated. Thanks

Hi guys. I have a 1996 xplorer 300 4×4. I’ve noticed when it gets hot it idles real low and is doggy and has terrible throttle response and no power. My air box that houses the air cleaner was cracked so I epoxied that up and noticed someone had put the wrong pilot jet in the carb so I put the correct one in. But I still have the same issue as when I started. I’ve fixed this thing up a bunch after buying it from my grandpa, new tires, drive belt, fixed air box, tie rod ends, and regular routine maintenance. I need to figure out this issue before hunting season and especially before winter since I plow snow with it. I appreciate any input. Thanks guys

Hello i’m working on a 94 300 4×4 Demand4Drive, the machine developed a problem where it won’t go into reverse. When you try to go into reverse you get a soft gear grind like it’s skipping on the gears but just won’t quite engage, if i have the machine idelling and pull it into reverse than give linkage a little extra push with my thumb it go’s into gear, i then made "adjustments" and can get either forward or reverse but not both on a set adjustment. Any ideas?

Thanks

Hello i’m working on a 94 300 4×4 Demand4Drive, the machine developed a problem where it won’t go into reverse. When you try to go into reverse you get a soft gear grind like it’s skipping on the gears but just won’t quite engage, if i have the machine idelling and pull it into reverse than give linkage a little extra push with my thumb it go’s into gear, i then made "adjustments" and can get either forward or reverse but not both on a set adjustment. Any ideas?

Thanks

2001 xplorer 250 4×4

I noticed last week the neutral light wouldn’t always come on. it I turned the key off and on once or twice the light would come on and itd start fine. now the neutral light wont come on at all so I have no electric start now. I can pull start it fine. where should I start looking? I checked the wires at the key switc and they all look fine.

I have a 98 explorer 4×4 if I turn left my front and rear chains loosen. Then when I turn right they retighten. Can’t see anything moving when I do this does anyone have any suggestions?