I just purchased a 2005 sportsman 700 twin efi. I rode it for 2+ hours and was very happy. Decided to give it a good bath (pressure washer), all went well. I started it 8 or10 times and rode it for 10 or so minutes. parked it in the garage and the next day it would not start.I finally got a manual and THINK that I have run most of the tests, now I’m thinking the ECU has gone bad?????? I could really use some advise before I spend $400.00 for something I may not need. The motor will turn over, no fuel pump or pressure. I have 4.5 volts going to the pump THANK YOU in advance for any help.

I just purchased a 2005 sportsman 700 twin efi. I rode it for 2+ hours and was very happy. Decided to give it a good bath (pressure washer), all went well. I started it 8 or10 times and rode it for 10 or so minutes. parked it in the garage and the next day it would not start.I finally got a manual and THINK that I have run most of the tests, now I’m thinking the ECU has gone bad?????? I could really use some advise before I spend $400.00 for something I may not need. The motor will turn over, no fuel pump or pressure. I have 4.5 volts going to the pump THANK YOU in advance for any help.

Worked most of the day today on my 2001 500. put the engine back together and then back in. Ran it down the street just a bit ago.having a hard time getting the coolant to burp but it runs like a champ!! Just need to put the plastics back on.

Attached Thumbnails

 

 

Worked most of the day today on my 2001 500. put the engine back together and then back in. Ran it down the street just a bit ago.having a hard time getting the coolant to burp but it runs like a champ!! Just need to put the plastics back on.

Attached Thumbnails

 

 

I have 2010 polaris 550xp. I have various bushings, ball joints, tie rods etc. That need to be replaced. Where is a hood reasonably priced place to get these things. I found some poly ones on eBay I don’t know if those are good or not though

I have 2010 polaris 550xp. I have various bushings, ball joints, tie rods etc. That need to be replaced. Where is a hood reasonably priced place to get these things. I found some poly ones on eBay I don’t know if those are good or not though

I have an oil leak, appears to be leaking from oil fill tube (dipstick tube) at the base. Has anyone experienced this? Is their a seal that needs to be replaced?

I have an oil leak, appears to be leaking from oil fill tube (dipstick tube) at the base. Has anyone experienced this? Is their a seal that needs to be replaced?

This 4-wheeler set up for while before I bought it. I cleaned the carb and it starts and idles fine but won’t rev up when I give it gas. If I put it in gear and try to give it gas it dies. Any thoughts on this?

This 4-wheeler set up for while before I bought it. I cleaned the carb and it starts and idles fine but won’t rev up when I give it gas. If I put it in gear and try to give it gas it dies. Any thoughts on this?