has anyone replaced the shift forks before? is it something that a person with mechanical sense can do? is there a video out there? any help will be appreciated..

Just purchased an 07 grizzly 700 a few weeks ago and last night I noticed some oil leaking near dipstick around water pump/ magneto gasket.Runs great but I really want to nip this in the butt before it gets worse. Any input would be helpful at this time. Thanks in advance. Picture included below.

Attached Thumbnails

 

I think the noise I’m having is because the pins on the cam shaft that go in the timing cog.control the decompression pin on the top of the cam I think I have this 180 degrees out. how do I set it. Keith this one’s for you

I have trouble shot everything from the forums I have read . How many people have seen a speed sensor stop working on these machines?

Sent from my iPhone using Tapatalk

2009 Grizzly 550
The clutch is "locked up" when the engine runs, it drives the atv, you can not roll the atv either with the engine shut off.

Any suggestions on what might be wrong?

I have pulled it down to the wet clutch and see nothing wrong.

How do you tell if the "one way bearing is bad"?

ok guys need a little advice. went out and played in the mud this past weekend.. got the bike stuck deep in some gumbo clay. took a 2500 chevy to pull me out , he bounced the front end of his truck and broke a tie rod….so that should help you understand how stuck i was.. so after i get it out it wouldn’t start i figured i flooded it hammering on the throttle to get out..i finaly get it started and all of the sudden i have no neutral, park, or basically any proper shit selection. ie if it shows its in neutral it goes forward, i don’t have a reverse. and i hear grinding in some of the gear selections.. although if i put the selector all the way up in what is suppose to be low it seams to run ok. what do i need to look at first or what order should i go in to eliminate possible problems to find out what the actual problem is? thanks in advance.

https://youtu.be/U4_5Xf6hnLU rebuilt whole top end everything is new. please help me head noise and throttle response. time is set. valve lash. is correct

I have an 03 Yamaha Kodiak that just like 2 weeks ago I was riding and now it doesn’t turn on. it cranks but doesn’t turn on.

I have an 03 Yamaha Kodiak that just like 2 weeks ago I was riding and now it doesn’t turn on. it cranks but doesn’t turn on.

I have an 03 Yamaha Kodiak that just like 2 weeks ago I was riding and now it doesn’t turn on. it cranks but doesn’t turn on.