Category Archives: Can-Am XMR

ok, need help

So im in the prossess of installing my monster power tuner, got the inner fenders off, side plastics, got the bung positions marked, yoshi exhaust off, removed the front header nuts, got to the rear header and the top nut was fairly easy, BUT, the bottom nut is givin me hell,, no room to get in there from the drivers side, tried the passenger side and the floor board is in the way, so I removed all the bolts on floor board, the two torx bolts front and rear and cant seperate the floor board from the front nd rear plastic,,, so any trick to get the rear bottom header nut off, and if it is to go in through the passenger side how does the footwel seperate from plastcs, thnx

ok, need help

So im in the prossess of installing my monster power tuner, got the inner fenders off, side plastics, got the bung positions marked, yoshi exhaust off, removed the front header nuts, got to the rear header and the top nut was fairly easy, BUT, the bottom nut is givin me hell,, no room to get in there from the drivers side, tried the passenger side and the floor board is in the way, so I removed all the bolts on floor board, the two torx bolts front and rear and cant seperate the floor board from the front nd rear plastic,,, so any trick to get the rear bottom header nut off, and if it is to go in through the passenger side how does the footwel seperate from plastcs, thnx

Problems with xmr

I got a 2014 can am xmr 650
I went riding today behind my house. It’s flooded back there. I was in the water for a while. After I got out I had some issues. I do have a snorkel installed and a 2 inch lift. Water was mostly up to just under top of tire level.
I had white smoke coming out of my snorkels… And I was losing power cause my belt was slipping. I did figure out that I had a lot of water in my belt box… I drained the box and water came out. I checked the oil and it doesn’t look milky at all. Looks like oil.
The one thing that baffles me is I checked the cvt drain , the dirty drain, and some oil drained out. No oil in the air box. Where did the oil come from? I drive bike home no problem. As long as I don’t hit it hard it drive and didn’t slip. I didn’t drain the box until I got home and read up on it. im hoping it will drive just fine tommorow…
Should I still change oil tom? Or is there anything else I should check?

https://www.facebook.com/jeff.peersm…3361298788940/

https://www.facebook.com/jeff.peersm…3361298788940/

TopEnd

going to be tearing down my top end over the holidays to build a new motor for next season any tips and tricks i need to know about? and also where is a good place to order a top end gasket kit?

Little mod.

The yellow on my xmr was boring me then i decide to remove the plastic and platidip all the yellow. There is a little view of it before it s done.
I will shonthe result tomorrow [emoji106]

Snow plow choices? Front mount or not?

2016 XMR 1000. What’s the best snow plow for a decent price? I don’t really want to pay $1000 for the can am flex plow, and don’t want to remove any skid plates or compromise ground clearance. Would a front mount plow be a good choice for easy installation/hook up?

What do you guys recommend for a reasonable price? It’s just for my 3 car driveway and sidewalks, not too much to plow.

Thanks for any help.

Alpine flex plow limit switch install

Hey guys. Wondering if someone has installed their own alpine flex plow with the limit switch that automatically stops the winch from going up. The instructions direct you to install the switch on the front of the plastic center shield. Has anyone done this installation with the BPR aluminum skid plates?