im going to extend my xmr snorkels, to just above the pod, seems like all the factory plumbing is 1.5 inch i.d, am I good to use 1.5 pvc? ive searched but not found a specific answer. im just going to cut the curved part of the xmr snorkels under the pod to slide in the pvc and rout it out up over the pod, like the SYATV kit does, I don’t see the need to pay 159$ when I can do the same for $40.
Category Archives: Can-Am XMR
Wheel Bearing Alternative
I have a 13 1000 XMR that eats Wheel-Bearings for lunch, any better alternatives out there???
Wheel Bearing Alternative
I have a 13 1000 XMR that eats Wheel-Bearings for lunch, any better alternatives out there???
1000 xmr exhaust
need help deciding between NPP supernasty or NPP dominator duals.
Fox Air Shocks
What is a take off set of Fox Air shocks worth?
I see them listed everywhere from 600-1k a set used..
Just picked up a new bike and miss my old Podiums from the 15
2013 XMR 1000 quit running
I was on a ride yesterday when all of a sudden my machine would run rough and my engine light would flicker on and off then it would just stall and check engine would display. I shut the key off and it would start back up run about 30 feet and the same thing. It did this 4 times and then all was fine ran it home 3-4 miles with no problems. Any ideas? Could I have been overheating?
2013 XMR 1000 quite running
I was on a ride yesterday when all of a sudden my machine would run rough and my engine light would flicker on and off then it would just stall and check engine would display. I shut the key off and it would start back up run about 30 feet and the same thing. It did this 4 times and then all was fine ran it home 3-4 miles with no problems. Any ideas? Could I have been overheating?
ceramic coating exhaust
So I want to get my exhaust ceramic coated. Does anyone know if you can coat exhaust that has been used? Mine has mud burned on it and what not, would I need to buy new exhaust?
Oil plug leaking 2016 XMR 1000
Has anyone changed their oil yet? Wondering if there is a washer on the drain plug? I put skids on and noticed the engine drain case plug leaking. Figured it was loose. There was no tightening it. I had to use a breaker bar to loosen it so obviously over torqued at factory. Its only got 1 mile on it. I didn’t look though if there is a sealing washer. If so maybe they didn’t install it? Maybe plug bad? Maybe they cracked case when over torquing?
Xmr L 570 rear seat?
Do they make some kind of rear seat for the L xmr 570?
Sent from my SM-N920V using Tapatalk