Tore my diff apart today to see it spines or teeth bad on diff because have grinding noise when one tire free and other is in bind nothing looked bad but did see on spider gears there is plastic tabs on both sides and on one side it is catching gear and binding up when I turn by hand could this cause the noise and not allow diff to lock?? Plz help thanks

I am installing new grips on my XMR today. (I was going to order ODI grips but I had already put an order in for the stock replacement grips) What glue is best? And I’ve read about some using 5 minute epoxy…

I am installing new grips on my XMR today. (I was going to order ODI grips but I had already put an order in for the stock replacement grips) What glue is best? And I’ve read about some using 5 minute epoxy…

Does anyone have a video on what all needs to be done to remove and replace front diff on 2014 outty xmr 1000?

Does anyone have a video on what all needs to be done to remove and replace front diff on 2014 outty xmr 1000?

So I am looking at getting a 2015/2016 XMR 1000. this is going to sound a bit dumb but i am going to ask it anyway. Every Picture that I have seen of the 1000 XMR shows it with out the second seat. Does this bike come with it or do i need to buy it seperatly.

Cheers
Chris

So I am looking at getting a 2015/2016 XMR 1000. this is going to sound a bit dumb but i am going to ask it anyway. Every Picture that I have seen of the 1000 XMR shows it with out the second seat. Does this bike come with it or do i need to buy it seperatly.

Cheers
Chris

Recently went out rideing with some friends and got buried!!!!! I mean buried!!! Had three 4wheelers and two winches and still couldn’t get out. Ended up getting a truck and breaking my winch cable and I made the stupid decision to hook to the bar on the rear that has an obvious sticker do not use to pull but I had nothing else I could get too, well the bar obviously come off and now my rearend looks like something is bent or off is it possible I bent the rack or frame or could it be in the suspension or what have I bent/broke/done to my bike?

Recently went out rideing with some friends and got buried!!!!! I mean buried!!! Had three 4wheelers and two winches and still couldn’t get out. Ended up getting a truck and breaking my winch cable and I made the stupid decision to hook to the bar on the rear that has an obvious sticker do not use to pull but I had nothing else I could get too, well the bar obviously come off and now my rearend looks like something is bent or off is it possible I bent the rack or frame or could it be in the suspension or what have I bent/broke/done to my bike?

With the summer heat my bike continues to die in deep water. I do need to pull it all down tomorrow and start checking connectors but I am getting no CEL, No water in the intake, no water in the CVT. Temp sensor on the dash just goes full cold and the bike stalls like it flooded out. Wait a few seconds cranks over just fine and I can pull right out of the hole like nothing is wrong once it figures out what it needs for fuel it seems.

Seems like the temperature shock is flooding the bike out, anyone else running into this? Just curious is all, just did 50 hour checkup with the exception of the valves, which I feel need done because I have noticed that the bike doesnt really have the bit it did even after last weeks bog.

Pond in question just for reference. If I keep the bike up, she’ll go through just fine, but twice this weekend had some people pull in the other side coming towards me and had to set it down on all 4 for a bit more control then she just died.