Category Archives: Can-Am Outlander

Not sure what to do ?

Ok for the last few rides my bike has no get up and go off the line, it just seem to sputter for a few seconds then takes off like a bat out of hell, it seems to get worse the longer I ride, It will even act up at half throttle if I punch it. I have replaced the fuel pump and the fuel filter. I also noticed that it will run like crap after going through water, engine light comes on, no codes though. My plugs are burning perfect. I checked all my connections, my grounds, getting good power from the battery, 12.6 not running, 14.4 running. I don’t know if my plugs would be so nice if it was the coil? I do have a fuel monster, maybe it’s that? Any advice would greatly appreciated.

28 mudder inlaws

Hey guys, i have a 13 outty 1000xt, i installed some 28 in mudder inlaws on 14 beadlocks and s 2 inch highlifter liftkit, i also trimmed a little bit of the plastic on the front wheelwells. I am still rubbing when the shocks are compressed any ideas on what i can do to prevent this from happening with out cutting more plastic off.
Thanks

What to pack?

Hey guys,

I’m trying to come up with a list of things I should pack so that I’ll be prepared for the unexpected.

So far I have…

– spare belt ( but I’m not sure what tools are needed to remove the panels and access it? )
– Air compressor
– Green slime
– tire patch kit

What else would you guys suggest packing?

What to pack?

Hey guys,

I’m trying to come up with a list of things I should pack so that I’ll be prepared for the unexpected.

So far I have…

– spare belt ( but I’m not sure what tools are needed to remove the panels and access it? )
– Air compressor
– Green slime
– tire patch kit

What else would you guys suggest packing?

XT-XTP Upgrade

Hey, sorry to beat a dead horse…

I’m looking to upgrade the cluster in my 2015 XT-XTP, but I can only find the part # for a 14 xtp cluster & pod.

Do I need to order a cluster/pod from a 15? or will the 14 work

thanks in advance

XT-XTP Upgrade

Hey, sorry to beat a dead horse…

I’m looking to upgrade the cluster in my 2015 XT-XTP, but I can only find the part # for a 14 xtp cluster & pod.

Do I need to order a cluster/pod from a 15? or will the 14 work

thanks in advance

looking at a 650

Hi guys been gone for a while……sold my 2012 800xt because to many issues eg clutch 2x power steering 4x , had it for 8 months with which 4 months were in shop …so bought a 2007 grizzly 700 nice machine but center hump and lack of the vtwin right now power = sold .
I am interested in hearing about the 650 s how is the power ?
I don’t need tonnes of power but miss the v twin for sure

looking at a 650

Hi guys been gone for a while……sold my 2012 800xt because to many issues eg clutch 2x power steering 4x , had it for 8 months with which 4 months were in shop …so bought a 2007 grizzly 700 nice machine but center hump and lack of the vtwin right now power = sold .
I am interested in hearing about the 650 s how is the power ?
I don’t need tonnes of power but miss the v twin for sure

new can am owner from down under. need advice please

hey guys,
Adam here from tassie, Australia.
Today i bought my first can Am.
its a 06 800 outlander.
I have a few issues which i am hoping to get some help with.
1. Is there somewhere online where i can dl a service manual (for free)
2. my dash wasn’t working.. i pulled it apart and cleaned it and now it turns on a works, however the fuel level bars do not appear, nor does the 4×4 light turn on when the 4×4 in engaged (4wd is working)
3. This one is a bit embarrassing. . Is there a knack to taking the air filter cover off? Seems to be fouling on the air filter and handle bars?

Thanks in advance guys.
cheers
adam

new can am owner from down under. need advice please

hey guys,
Adam here from tassie, Australia.
Today i bought my first can Am.
its a 06 800 outlander.
I have a few issues which i am hoping to get some help with.
1. Is there somewhere online where i can dl a service manual (for free)
2. my dash wasn’t working.. i pulled it apart and cleaned it and now it turns on a works, however the fuel level bars do not appear, nor does the 4×4 light turn on when the 4×4 in engaged (4wd is working)
3. This one is a bit embarrassing. . Is there a knack to taking the air filter cover off? Seems to be fouling on the air filter and handle bars?

Thanks in advance guys.
cheers
adam