Anyone want a low mile set of Gen 2 Elkas? $800.00 shipped anywhere in the CONUSA (firm). Have the receipt from new showing over $2k spent. Maybe a couple of hundred miles on them at most. Still have the adjusting tool and all paper work with original box. Pic is when I got them, they are a little dirty now from use:aniwheeler6:

Please e-mail hemiheadt1@optonline.net

Attached Images

elka stage 2+R.jpg (93.8 KB)

Anyone want a low mile set of Gen 2 Elkas? $800.00 shipped anywhere in the CONUSA (firm). Have the receipt from new showing over $2k spent. Maybe a couple of hundred miles on them at most. Still have the adjusting tool and all paper work with original box. Pic is when I got them, they are a little dirty now from use:aniwheeler6:

Please e-mail hemiheadt1@optonline.net

Attached Images

elka stage 2+R.jpg (93.8 KB)

Hi. Super long story short, my father in law gave us two Can Am Outlanders last summer. We had hopes of using them but I travel way too much for my work and they’ve just sat in the garage. So, I’m going to put them up on craigslist. But haven’t a clue how much I should be asking.

Here’s what I know.

2007
Can Am Outlander 650 XT (High Output)
189 and 207 Engine Hours

Here are some pics I just took. Any help would be awesome. Sorry, I don’t know much about ATVs. Thank you.

http://i.imgur.com/z9PtVRg.jpg?1

Imgur: The most awesome images on the Internet

Imgur: The most awesome images on the Internet

Hi. Super long story short, my father in law gave us two Can Am Outlanders last summer. We had hopes of using them but I travel way too much for my work and they’ve just sat in the garage. So, I’m going to put them up on craigslist. But haven’t a clue how much I should be asking.

Here’s what I know.

2007
Can Am Outlander 650 XT (High Output)
189 and 207 Engine Hours

Here are some pics I just took. Any help would be awesome. Sorry, I don’t know much about ATVs. Thank you.

http://i.imgur.com/z9PtVRg.jpg?1

Imgur: The most awesome images on the Internet

Imgur: The most awesome images on the Internet

I noticed my master cylinder leaking brake fluid . The screws were not overly tight , so I tightened them but it still leaked. so I took the cap off and the rubber diaphragm seemed folded up like an accordian, so I took it out and put it in the normal position. now when adding brake fluid do you take the rubber diaphragm out to fill it ., then put the diaphragm back in and tighten it down. not sure why the diaphragm ended up distorted like that. I have never touched it otherwise, only the dealer.