Has anyone been to the Spearhead trails yet? Any other good systems nearby. Doesn’t seem too far from the couple in TN.

Has anyone been to the Spearhead trails yet? Any other good systems nearby. Doesn’t seem too far from the couple in TN.

anybody have a mapping for my outty with twin air filter and hmf swamp full exhaust.

Thanks!

I’m looking for an adjustable kit for my 07 Outlander 650
Thanks

I bought a used can am and it runs great, but I’m concerned on this starting issue I’m having.

If I put the key on and start it, it starts right up. If I turn the key to off and then quickly back to on and try to restart it, it won’t start it will just crank. If I pull the key out and wait till the screen turns off and then key it back to on it will start up.. Don’t know if this is a normal function or not as this is my first ATV.

Local dealer won’t even give me an idea or anything unless I pay them 95$ so see if I can’t try to fix it myself

I added the 20 inch Cree light bar a while back. The wiring kit they sent was junk, it started flickering after 1 ride. So I cut the high beam and ground wire to the headlights (they are 16 gauge) and spliced the 12 gauge light bar wires into them. So I have had it running fine for 3 or 4 months with the 16 & 12 gauge running into a 16 gauge. Now when I turn the wheel it fades out, my guess is because the electric power steering taking battery power. So would changing the wires to run the 16 & 12 into a 18 gauge wire help this? How do you guys have your lightbars running with your headlight switch?

Getting some options out there. I am going to do a snorkel it and rad relocate kit. Witch one would you do first? (can only do one at this time)

Is there a large volume Can Am dealer in the SE part of the USA? Any where east of the Mississippi?

I have found Kawasaki, Suzuki, and Polaris ATV’s through large volume dealers that offer their units below MSRP with no dealer fees. Hoping there’s a Can Am dealer that can do this. Any suggestions?

Hello, I have a new 500 XT two up with less then half hour on it. I noticed a noise coming from the left side when I start off, Kind of a clunking noise when I start off. From the sounds of it I’m thinking it’s the clutch slapping the belt.if that is what it is then can anyone tell me is that a common thing to expect Or should I be looking closer? It does seem to be coming from the left side.
Thanks for any ideas/comments!

Hey guys , I joined this forum about 8 months ago but haven’t posted or anything here’s my bikes so far-
2014 outlander 800 xt

Clean-

Mods are-
brp snorkel,brp rad relocate, rox 2 inch risers with fly bars. Rjwc slip on exhaust , dobeck 3.5 controller, cv tech primary tuned by get torqed, 28 in zillas , 1.5 wheel spacers, elka stage 4 shocks!