I currently have the BRP snorkel kit on my 2014 1k Outty. For various reasons, need to switch to the stealth setup like the XMR has.
Has anyone made this swap? Any tips or a parts list? Looks like I will only lose a few inches of height.
Thanks
I currently have the BRP snorkel kit on my 2014 1k Outty. For various reasons, need to switch to the stealth setup like the XMR has.
Has anyone made this swap? Any tips or a parts list? Looks like I will only lose a few inches of height.
Thanks
Anyone bought from them? If so does the kit come with everything needed including the hole saw for the snorkels to drill out the pod ? About how long does it take to install? Btw it’s going on a 2015 CAN-AM outlander 1000 XTP. Thanks for the feedback.
hey guys i’m new to the forum. i’m looking to lift maybe 2-3" to help clear my tracks. sometimes they rub my fenders. I don’t have much experience with lifting atv’s. do I just install blocks on top of my shocks? what are the disadvantages of lifting? will I put more strain/ load on my a arms, steering shaft, cv joints, etc. ? I have a 2015 outlander max xt 1000cc with the 360 aplache track kit
hey guys i’m new to the forum. i’m looking to lift maybe 2-3" to help clear my tracks. sometimes they rub my fenders. I don’t have much experience with lifting atv’s. do I just install blocks on top of my shocks? what are the disadvantages of lifting? will I put more strain/ load on my a arms, steering shaft, cv joints, etc. ? I have a 2015 outlander max xt 1000cc with the 360 aplache track kit
So I tried researching this but everything I found gave me no results. The issue I am having is after about 30 minutes (or at least until the engine gets hot) I cannot accelerate past about half throttle without the four wheeler cutting out. It almost feels like the four wheeler has a governor. I thought maybe it was overheating but my radiator is clean and full of fluid. The fan runs fine as well. I put new plugs in the other day and that didn’t fix anything either.
I am not getting any kind of check engine lights nor does the LIMP MODE appear on the screen. I am out of ideas of what this could be so any help would be much appreciated.
BTW I have 2008 Outlander Max XT. No engine mods either.
I just bought a 2015 CAN-AM outlander 1000 XTP and I noticed that when I shut it off and remove the key the brake lights and instrument panel stays on for a minute or so is this normal?
