Okay months later I broke my axle on My can Am I was Kinda Piss at The moment til I got home An look up some axles! Man I know everybody loves gorilla or turner axles or whatever high brand an HIGH price people talk about but I tried Sixity axle cause it was on eBay for 109 so WTH I gave it a Shot it’s a Great axle & Great quality I don’t see why some people spending a lot on axles:/ I haven’t had any problems with the bend or nothing it’s good for the price I REALLY recommend this Axle but they make more than axles give them a look you Won’t be disappointed in My Book!An No I’m Not a sponsored by them…just a trail rider.

I had a very unfortunate experience with Team industries last week. I want to share my experience with everyone in hopes it can save some one from the same outcome. I had over 12k invested in an awesome Can am Maverick setup. Unfortunatly a team clutch was part of my upgrades and after only 100 miles. (Stock clutch lasted 500 miles and was perfect when I did the supposid uprade) The Team industries cluth absolutly exploded and shot a ramp ( with the nut and bolt) through the plastics and stuck in the back of the drivers seat. If it would have been 3" higher this would have gone through the hole in the seat and stabbed me in the neck. Team industries states they only recommend their clutch for stock applications. (interesting as aerocharger includes them with their kit) Team also states that they offer no warrant on their products and it is on the consumer as this is a performance product. I even spoke with Mark the plant manager and he went as far as stating that they dont even have a warranty department. I asked him were the vm for prompt #2 went as it states warranty department on their greeting, he did not have an answer for me. After hours of debating with team industries so called warranty department they will not stand behind their product or do anything for me. When the clutch exploded it took out the motor and several other parts. I am now forced to sell my maverick in pieces due to my trust in team industries. Do your self a favor and spend the extra $ on the STM primary as it could cost you everything if you dont.

Thank you for reading this post

Darren

So i recently bought 10 highlifter DHT axles for 3 seperate machines. Put 4 on an outlander 1000, 4 on a Renegade 1000, and 2 rears on a 650 Xmr. 5 minutes into the 1st ride of the season the 1st axle fails on the rear of the Renegade. It looks as though the clip that holds the CV into the Cup fell out and the whole joint pulled out loosing all the bearings. This machine was disabled and towed back to the trailer. Later in the day being nervous of more failures i looked at the axles on the 1000 Outlander and noticed that both boots on the right front axle came off. So worried that Highlifter would not warranty i took pictures while still clean. Obviously this ruined my ride because now i am dodging all the water and mud. When we get back to the trailer I looked at the axles again and the left front has grease coming out of the boot on the inner joint. Needless to say i am not impressed with Highlifter right now. I only hope that their customer service is better than their workmanship. Maybe i got a bad run of axles but now i am down 2 machines while waiting for replacements.