Would it void my warrentie if I use die electric grease on my plugs in on my 2015 rubicon

I got this atv and it had no compression. I pulled the jug and the wrist pin was seized in the connecting rod!!!! What causes this and can I replace just the top end? There is a few burs in the connecting rod but I think I can smooth them out! Also if this is not a option and I end up doing an engine swap can I up the engine to. 6 or 700??? If so what year engine!?? Any help would be greatly appreciated!!!

Sent from my iPhone using Tapatalk

Hi men, been offered some good plastics off a 450s, apparently, could they be persuaded to fit on a TRX 300 at all? Would it be worth it (got a 300 with no plastics).

Cheers men

Hi men, been offered some good plastics off a 450s, apparently, could they be persuaded to fit on a TRX 300 at all? Would it be worth it (got a 300 with no plastics).

Cheers men

I need some advice from you veteran ATV’ers.

I have a 2012 Polaris Sportsman 550 that I purchased new and use just for plowing in the winter and the occasional "chore" around my property, like hauling wood, moving a trailer, etc. It does not go out on trails or do any off roading. I take it in each fall to have the oil and filter changed and have it inspected by the mechanic. They always tell me everything looks good. Should the demand drive fluid, rear gearcase oil or transmission oil or anything else be changed at this point ( 3 years). I just want your opinions before I pose this question to the people at the place where I have it serviced.

I’ve lost my owners manual.When you change oil filter,does the small rubber O Ring go on the inside or the outside?Thanks

I’ve lost my owners manual.When you change oil filter,does the small rubber O Ring go on the inside or the outside?Thanks

shift for explorer is stuck in low. it had become tough to hold in high. it would shift to high but when you hit the throttle it would pop out. i put it in low to load and now its stuck there. suggestions?

Anybody have any experience with these?