Buggy with Trailblazer engine

Good day

New to the forum and I think this is the best place to get some help.

I know nothing of Polaris, as these are not abundant in South Africa.

Got this yesterday, and has a Trailblazer engine in, and utilizes the suspension as well. The quad frame was welded on the buggy frame as you will see in the pics.

Will post a pic and short questions and comments above each pic.

Picking it up. They pull started it ran for a bit then died. Was overflowing but already sorted that out and cleaned jets.


I do have the cover. The belt currently installed is not correct and will have to be replaced. What size belt do I need to get?


How is this supposed to be wired?

This fuel line that tied off, where does this go?

When I got it, these two were connected without a t piece. Now they are connected with the t piece installed and the black tube is open to allow dripping. The fuel mix screw is 2 and half turns out.

This is the oil pump right? I see it is not connected, so will have to pre mix. Is it OK to leave it on as is, not connected to anything / open?

This is on the right side of the engine / tranny. I assume this is a plug to show gear position / indicator? Correct?

The guy said the starter has some issue but he does not seem to know much himself. Maybe not connected properly. I see no starter relay. How should this be connected?


What the heck is this? Not connected to anything.

The tank has two outlets, the one is not connected / open. Where should it go?