I wasn’t sure if I should put this in the roll cage/ safety section or here, but here’s my Wife’s new ride.
We bought it about 6 weeks ago. I unloaded it off the trailer and ripped a few donuts in the shop. The next day my wife got it out to show off to the neighbor and laid it on it’s side within seconds! We knew we were going to do a roll cage but that pretty much set it in motion without hesitation. So here’s our 1000s that we started building on. I will continue adding pics as we finish it.
The rollover broke both fenders on the passenger side. So I took those off and tore it down to get to the cage.
Picked up these cage bungs from Branik Motorsports in Ft. Wayne, IN. These are also on Wide Open Designs webpage.
Cut some clean notches with the Versanotcher from RogueFab.com
We still have to work on bumpers. Then I will have to make some brackets for the factory door mount and harnesses. I will post pics of updates as we go but this is where we are as of Christmas evening.
We bought it about 6 weeks ago. I unloaded it off the trailer and ripped a few donuts in the shop. The next day my wife got it out to show off to the neighbor and laid it on it’s side within seconds! We knew we were going to do a roll cage but that pretty much set it in motion without hesitation. So here’s our 1000s that we started building on. I will continue adding pics as we finish it.
The rollover broke both fenders on the passenger side. So I took those off and tore it down to get to the cage.
Picked up these cage bungs from Branik Motorsports in Ft. Wayne, IN. These are also on Wide Open Designs webpage.
Cut some clean notches with the Versanotcher from RogueFab.com
We still have to work on bumpers. Then I will have to make some brackets for the factory door mount and harnesses. I will post pics of updates as we go but this is where we are as of Christmas evening.
