Ok guys have a 2012 RZR4 RGE 800, has 3 inch lift 29.5 Terminators on it. A couple weeks ago we spun a EPI severe duty belt while pulling a bunch of 4 wheelers out of some gumbo mud. Belt came apart, blew it into a million pieces, etc. So we went back to camp, put on a spare belt, drove it 500 yards and it came apart. So we took it back apart and found some pieces had gotten into the snorkels and came back into the clutch when we took off and messed that belt up. We put on a 3rd belt and were able to ride about 30 minutes before the front (toward front of vehicle) was separating so we loaded up and came home. I got home got it all apart, and found a nick on the edge on the secondary where it is recessed. I took a file and some emery cloth and smoothed it out. I pulled both clutches, serviced and cleaned the faces, installed a TAGTEAM clutch kit and new EPI severe duty belt. Last week I finally had time to get it out cause I wanted to see the difference in clutches. I rode slowly in low heating up the belt etc. Once I shifted it into high I started hearing a bunch of racket so I took it back home and pulled the cover only to find the front edge of the belt shredded again!!! I replaced the secondary with a new one and it did it again with another belt!! I pulled the primary and the plastic bushing on the bolt is all messed up. What else can it be?? What am I Missing?? ITs only the front side of the belt and its busting off the top cogs and leaving a groove