Ok so I put the windshield on the Forman…. and I hate it. Long story short I’ve always had them on my quads but I have never had a third light in my way. Now I’m not sure what to do. I had to mount it two inches further out then the stock mounting provided and it makes it sit a little high and a little more forward then I like. I’ll grab pictures tomorrow…. the windshield was on sale for 100$ reg 300 so I don’t feel bad about modding it. But what are the thoughts. I’m wondering if there is an easy way to get rid of that light (it has the instrument cluster attached to it).. I’m ok with losing the speedo but would like to keep the lights (neutral, reverse). Is there a way to do this? Or do I cut up the windshield to fit everything?
I’ll get pics of how it looks now and hopefully figure out a good solution.
before I blow this thing up hopefully you guys can help me find my issue. 2004.5 sportsman 400 turns over no problem. But no spark ive replaced pretty much everything that has to do with the ignition/spark system if you wanna call it that still no spark. the only thing I havnt tried yet was the ECM paying the money for one is not what I want to do unless I have another thought about that being the problem. Any helps appreciated.
before I blow this thing up hopefully you guys can help me find my issue. 2004.5 sportsman 400 turns over no problem. But no spark ive replaced pretty much everything that has to do with the ignition/spark system if you wanna call it that still no spark. the only thing I havnt tried yet was the ECM paying the money for one is not what I want to do unless I have another thought about that being the problem. Any helps appreciated.
While on a ride today, on a WOT run hat flew off and slammed the brakes then the bike died. was hard to start after that but ran fine under throttle, then when I stopped a few minutes later it was idling rough and died after 30 seconds. The bike runs fine under throttle but idles rough. It quit dying at idle but still runs rough. I don’t have a fuel controller and currently have the stock tip on the muffler. Appreciate any help.
Ok. I have a 2006 Hawkeye. When I hold it wide open it tries to die, kinda of starving for fuel.
I pulled the carb and cleaned it. Same results. I then took the carb off of another Hawkeye that has been running fine,. Same results. Left the carbs switched , other bike ran fine. Any ideas
Trying to do first oil change on my 2016 570 xmr. I have removed the side panel and am trying to remove the footwell. I have removed all pushpins and nuts and bolts. It is loose now but I can’t seem to get the footwell separated from the front and rear fenders. What is the trick to this? Is it possible to change oil filter without removing this. I really like this atv but nothing is easy to work on. Thanks
I’ve put in new fuel pump and cleaned tank, new plugs, new tbap or tmap wiring harness, cleaned tbap sensor with proper cleaner, knocked carbon out of exhaust, and tried to clean injectors. Each time after doing all of these things, it runs fine for 5-10 minutes then bogs down at higher rpms and goes to nearly nothing or dies. I let it set for a while and it can go again for a short time. I’ve read a lot of threads about this kind of problem but can’t figure out this. Also ran with gas cap off, checked fuel tank vent lines, etc.
