All posts by dstech

camshaft info

hello boys!
I need an info. I would to change mine camshaft from mine renegade 500, so I have found more cameshaft to buy.
The info that I would is : Can I install the new camshaft with 3 bolts in my 2009?
I have just found a pair of camshaft from a 650 g2 machine…
very thanks

Francesco
-italy- (sorry for my bad english)

polaris scrambler 850 xp

Hi, can anyone help me or advise me? I have a 2013 850 scrambler and I’m having a few drive shaft problems on the front only.
I have put a full set of outlaw tires on this machine and they are bigger than the stock tires.the rear are 28x12x14 and the front are 28x9x14.
The bike has covered 400 miles and this is the second one that has snapped clean in half.
i would upgrade the dive shafts but i can’t find no replacments?

thank you in advance for any help thats out there?……….

polaris scrambler 850 xp

Hi, can anyone help me or advise me? I have a 2013 850 scrambler and I’m having a few drive shaft problems on the front only.
I have put a full set of outlaw tires on this machine and they are bigger than the stock tires.the rear are 28x12x14 and the front are 28x9x14.
The bike has covered 400 miles and this is the second one that has snapped clean in half.
i would upgrade the dive shafts but i can’t find no replacments?

thank you in advance for any help thats out there?……….

throttle cable trx 200

Can the throttle cable on an 86 trx 200sx with the stock cable pressed into the carb cap be replaced without replacing the carb cap? I would like to change the carb and use the stock cable if possible.I don’t want to ruin the old carb cap if at all possible.Thanks,Larry

Pretty stoked about Viscolok…..seems to work pretty good

Hello all.
So I was out on my 2016 Outlander L 570 for the second big ride. I got it stuck in the first ride in some really deep snow, and all 4 wheels spun.
Today I got crossed up in some ruts, and the front right wheel was about 8" off the ground, and almost without hesitation, the front left was tearing a hole in the dirt. Perfect! I like the fact it’s always there and ready when the hole or ruts are deeper than expected. About half an hour later, I was climbing a sand hill with a right hand turn at the top and the bottom, and it was steeper than expected, nail the throttle and at both obstacles, front end locked fast and away we went. I can say with my Grizzly, it would have been a back out into the deep water, lock the front (which wasn’t always instant), and fight with the locked front end and then unlock at the top. Not the end of the world, but damn I like this Can-Am way better.

A note on handling, the back end sure steps out smoothly and consistently all the time. The engine is awesome as well, smooth and sounds awesome. So happy I ditched the Yamahaha.

Replacement bulbs for ’16

I just picked up my ’16 Kodiak 700 EPS and am having a really hard time finding replacement LED bulbs for the top/bottom head lights and tail light.

I was looking for a drop in replacement to take advantage of existing seals, wiring, etc..

Any pointers?