Since the G2 rads are bigger than the G1 it has been suggested that I put one on my 2012 650 Max, which has a G1 frame. Does anyone know if the G2 radiator will fit without many modifications?

Like many posts – Won’t shift.
What do 4 fast blinks and 2 short blinks mean.
Last year I replaced the angle sensor and worked for another year.
Now in same boat. But, don’t remember what error code was getting last year.

Like many posts – Won’t shift.
What do 4 fast blinks and 2 short blinks mean.
Last year I replaced the angle sensor and worked for another year.
Now in same boat. But, don’t remember what error code was getting last year.

Hi everyone. My name is Sean and I’m new to this forum. I recently got a used ATV. It is a 2003 Honda 300EX. I am in the process of installing new tie rod ends and I came across a problem. The replacement tie rod ends are much smaller than the ones I took off. Not only are they shorter but the bolt is also smaller in diameter.
A friend of mine suggested that maybe the ones i removed were an upgrade that were larger than the stock ones. They look stock but i don’t know for sure.
Can anyone tell me the dimensions of the tie rod ends that come stock on 300EX?
The ones that I removed are 3" long and the bolts on them are 7/16" diameter.
The new ones are 2 5/8" long and the bolts on them are 3/8" diameter.
[ATTACH]Attachment 47034[/ATTACH]

Attached Thumbnails

 

 

Hi, I just purchased a 2009 Renegade 800 completely stock and was wondering if 28×10-12 up front and 28×12-12 back zillas would fit without rubbing? I will be using the stock rims. Will I need spacers or anything?

My battery keeps going dead there is about a constant 10 amp drain on it. I have unplugged the speedo cluster. Unhooked the three fuse/ breakers behind the front panel one
a time. Nothing I’ve done stopped the drain. Anyone have any ideas

I’m new to this form my name is Kyle I have a 2013 xmr 1000 all stock after riding for a while and then going off in a mud hole and putting it is reverse and hitting the throttle the bike revs up and it sounds like the intake is blowing or sucking air along with sputtering causing it not to shift out of reverse after hitting the throttle while forcing the shifter to high/ low it will finally go in to high/ low but the noise / reving will not go away till I hit the throttle again has anyone had any problems with this and what do y’all think it is thanks

Sent from my iPhone using Tapatalk

Finally broke down and wrapped my 500 Touring. It was Red, and getting pretty scratched up due to trail riding. I am not a camo guy, so decided to be a little different. I am happy with the results. Took forever! Needed lots of Patience for sure!

Went riding this morning and was doing some cleanup on the trails and a few times I’d hit the start button and get no response or a quick crank and then nothing. Question is, is the starter to blame or the solenoid? I do not hear any clicking when hitting the button so my guess would be the solenoid but don’t have a whole lot of experience with starters.

has anyone used a electric water pump and just remove the impeller on a 800 renegade ? , my 800 gade I just purchased needs the gears replaced inside the engine and I think an electric pump would be a better solution to solve the issue, whats everyones thoughts ?