Advice on removing rubber seals before powder coating

Hi new to the forums. Just recently picked up an 08′ TRX250. Decided it needed a new paint job, due to all the surface rust.

I plan to have it sandblasted and powder coated black. However, one thing is holding up the process. These rubber seals/gaskets at the end of each arm. Not 100% sure if these can be removed.

Just wanted to see, if anyone else had any experience with them.

When I look at the break down, I don’t think these ends can be pressed out. If they can be pressed, not sure if they can be reused. Not to mention, were to get damaged in the process, how to replace them. Doesn’t seem like it’s an replaceable item, but more of the arm makeup.

I can only assume the arms can’t be powder coated??? Seems like the same issue with those, who can’t remove the ball joints on other arms.

Shop did give me other options to do epoxy/paint or POR15 w/ Hardnose. Might just have to go with one of those and powder coat the frame.

Thanks in advance for any info on these seals and arms.

Click the image to open in full size.