Can’t seem to find a thread on how to remove the a-arms on my 04-700 twin. I was trying to get them out so I can get to the prop shafts in the front and rear.
I know that I can remove the shafts without pulling these, but it sure makes easier to get them out of the way.
After removing the bolt from one side…..the other side just spins. Any advise would be greatly appiceated.
I did find where someone adds extra zert fitting to them. Will most-likely do this too.
I know that I can remove the shafts without pulling these, but it sure makes easier to get them out of the way.
After removing the bolt from one side…..the other side just spins. Any advise would be greatly appiceated.
I did find where someone adds extra zert fitting to them. Will most-likely do this too.
Hump.