94 polaris 400l new “generic” key switch wiring question

New to the Polaris forums.
I purchased a 1994 400L 4×4.
It was missing the ignition switch. I bought a new non OEM switch on ebay.
It is a four wire just like the OEM, but the wires are red,brown,black and black with white. When I turn the key on I get power in and out of the red and brown wires. So brown is not ground like OEM.. My question is where would you think I need to hook up the wires to the terminal board.??

I know the red goes to red on the board for power and I would think the brown would go to the the red/white on the terminal board since i have power out there,right?

The two other blacks/black w white ? where would those go on the board.

Also where does the terminal board gets it ground???

I have not quite figured this out.

I also am missing the CDI…still trying to find one.

I hope this all makes sense

Thank You

94 polaris 400l new “generic” key switch wiring question

New to the Polaris forums.
I purchased a 1994 400L 4×4.
It was missing the ignition switch. I bought a new non OEM switch on ebay.
It is a four wire just like the OEM, but the wires are red,brown,black and black with white. When I turn the key on I get power in and out of the red and brown wires. So brown is not ground like OEM.. My question is where would you think I need to hook up the wires to the terminal board.??

I know the red goes to red on the board for power and I would think the brown would go to the the red/white on the terminal board since i have power out there,right?

The two other blacks/black w white ? where would those go on the board.

Also where does the terminal board gets it ground???

I have not quite figured this out.

I also am missing the CDI…still trying to find one.

I hope this all makes sense

Thank You

94 polaris 400l new “generic” key switch wiring question

New to the Polaris forums.
I purchased a 1994 400L 4×4.
It was missing the ignition switch. I bought a new non OEM switch on ebay.
It is a four wire just like the OEM, but the wires are red,brown,black and black with white. When I turn the key on I get power in and out of the red and brown wires. So brown is not ground like OEM.. My question is where would you think I need to hook up the wires to the terminal board.??

I know the red goes to red on the board for power and I would think the brown would go to the the red/white on the terminal board since i have power out there,right?

The two other blacks/black w white ? where would those go on the board.

Also where does the terminal board gets it ground???

I have not quite figured this out.

I also am missing the CDI…still trying to find one.

I hope this all makes sense

Thank You