We have had several complaints from our customers about the filter housing on their 900s, 1000s and the ACE 900. After getting our ACE 900 we went to work to see what was going on. First thing we noticed was the upper portion of the lid did not seal at all. The straps holding the lid closed were way to soft and the lid was warped at the ends and in the middle. The sides and lower section of the lid seemed to seal well but there was just not enough even clamping pressure across the top to get a good seal.

Something need to be added so we could get it to seal, so I busted out a set of our straps that we make and use for the XP900 hood and Xp1000 glove box. They ended up fitting the bill perfectly and now we have a complete seal of the filter housing.

To do the install you will need to remove the housing from the vehicle and it does take a little time, but the end results is well worth the effort.

Finalizing our instructions and should have kits available shortly.
Regards,