I have started my first quad project. I have done 73 & 74 ATC’s and there are similarities, but this is a 4 speed. I purchased this with the engine in pieces.
I am trying to find out what position the gear drum and stopper plate should be upon install.
Also, does it matter that the case doesn’t have the smaller needle bearings in the holes where the transmission ends are inserted? I have all the parts for the transmission, including all the washers. It just seems like the trans. is awfully tight to turn when I close the case up and bolt it together.
Any advice appreciated.
Thanks
I am trying to find out what position the gear drum and stopper plate should be upon install.
Also, does it matter that the case doesn’t have the smaller needle bearings in the holes where the transmission ends are inserted? I have all the parts for the transmission, including all the washers. It just seems like the trans. is awfully tight to turn when I close the case up and bolt it together.
Any advice appreciated.
Thanks