Got a chance to run the quad a little bit tonight. Just installed a CVTECH and STM. From a slow roll, when I pin it the RPMs jump to about 7050 and then drop and hold at 6850 through the pull ( until I run out of room). I don’t know yet how the primary is set up but will be calling 3P for info Monday. The helix in the secondary is a 40 EN and I believe there are 3 fiber washers installed. I believe this shift out is a little low. What is my target shift out rpm and any thoughts on how to get there would be appreciated. Also, I use the homemade 2 bolt method to remove the stock primary. Will this be OK to use on the CVtech? Thank for your input.