2001 Grizzly 600
So here’s what has happened
Got the grizz all put back together and the only thing left to do was add some air to the two front tires, drove the bike about 50 ft around the car to get to the other side of the garage to my air compressor and while it was idling it stalled and i have not been able to get it running since —except for ONCE about a day later while the bike had sat it started and ran for about 30 seconds and then once again stalled and has not started, it just keeps turning over.
I know the electrical is good, the battery is fully charged, the plug is literally brand new on it, and the gas is brand new and coming out of the gas line. The carb has just been cleaned by a small engine guy who knows his stuff pretty good, or at least i had hoped so lol!!!!
I’m wondering if it might have something to do with the float bowl thingy inside?? could it possibly be sticking??
Also while the bike was first idling it was idling a bit fast, and therefore would not go into gear without a big clunk and i didn’t want that to happen so i adjusted the thumb screw thing on the side of the carb to slow it down a bit…could this be an issue??? if so how do i know how to readjust it back to a normal proper setting??????
Any thoughts or ideas would be most appreciated, i was so happy that the grizz was rurally running, and now it seems that’s not the case grrrrrrrrrrrr!!!!!!!!!
CAN’T FREAKIN’ WAIT UNTIL I CAN AFFORD A NEW BIKE WITH EFI!!!!!!!!!!!!!!!!!!!!!!!!!!!!!