OK I had qsc clutch kit installed over week ago now. I’ve found that when I 1st crank the 570 it will idle 1350 to 1450 rpms and it seemed harder to shift till I put in gear and drive it for a few minutes then it will idle at 1250 to 1300 rpms and easier to shift. There has been a few times I’ve cranked it after it been sitting for day or 2 and put it reverse or low but have giving it any throttle yet. Reached to shift to a different gear and it would not budge until I turned it off then cranked it again then the lever would should shift out of the gear it was stuck in. I’ve checked it without 570 running and it shifts flawlessly. This on a 2016 570 EPS. Any ideas?

OK I had qsc clutch kit installed over week ago now. I’ve found that when I 1st crank the 570 it will idle 1350 to 1450 rpms and it seemed harder to shift till I put in gear and drive it for a few minutes then it will idle at 1250 to 1300 rpms and easier to shift. There has been a few times I’ve cranked it after it been sitting for day or 2 and put it reverse or low but have giving it any throttle yet. Reached to shift to a different gear and it would not budge until I turned it off then cranked it again then the lever would should shift out of the gear it was stuck in. I’ve checked it without 570 running and it shifts flawlessly. This on a 2016 570 EPS. Any ideas?