This was also posted on my "Jokers Wild" build thread but for those who didn’t see it, here it is on the Projects and How To.

While I was installing the new Super Dave bushing kit I decided to install the new winch while I was there. I took the front grille off for easier access. The front bumper had to also be removed because the fair lead plate goes behind it. I started thinking about a front tow hook or "D" ring but with the Polaris front bumper, there are not many options. As most of my projects begin by making conceptual sketches to eliminate the possibilities that won’t work I came up with this. I used a large "D" ring which fits between the lower tubes on the bumper and bolted it thru the bumper holes. I attached the sketches if you want to build one. If you use the sketches and photos, it will not be hard to determine the dimensions starting with the "D" ring. Note that the top of the angle iron is notched on each side so the "D" ring can swing up past horizontal. Be careful when laying out the ring and bolt holes that it does not extend below the bottom of the vehicle. I am going to use it to attach the winch hook to when I get done with the installation. So take your time and have fun, that’s what it’s all about! :ok: