I have a 2014 RZR 570 LE/EPS with about 140 miles on it and its out of warranty. When I try to start it, the engine cranks over normally, but it just won’t fire. There are no codes displayed and the display looks normal from what I can tell. The gas tank is full.
I had noticed previously, that after turning the ignition key off, a few seconds later a short electrical rat-tat-tat sound came from (I think) somewhere in the engine area. That sound no longer happens when the key is turned on and then turned off. (What causes the rat-tat-tat sound and could that be the cause of the problem?)
The RZR had been sitting for a few weeks since I last started it. I do have a dual-battery setup (dual Odyssey PC925 batteries that are about 4 months old) with a TRUE isolator that is working properly (blue light is on). The batteries are fully charged, reading 12.5 and 12.7 volts respectively. (I keep a trickle-charger on it.)
I recently (last week), installed the EZ- Running light & Turn Signal kit. I wouldn’t expect that to have caused a problem.
I’ve checked and I have power to the coil and I’ve checked many other connections and all seem to be powered correctly.
Everything else seems to be working perfectly… it just won’t fire.
Any ideas?
I had noticed previously, that after turning the ignition key off, a few seconds later a short electrical rat-tat-tat sound came from (I think) somewhere in the engine area. That sound no longer happens when the key is turned on and then turned off. (What causes the rat-tat-tat sound and could that be the cause of the problem?)
The RZR had been sitting for a few weeks since I last started it. I do have a dual-battery setup (dual Odyssey PC925 batteries that are about 4 months old) with a TRUE isolator that is working properly (blue light is on). The batteries are fully charged, reading 12.5 and 12.7 volts respectively. (I keep a trickle-charger on it.)
I recently (last week), installed the EZ- Running light & Turn Signal kit. I wouldn’t expect that to have caused a problem.
I’ve checked and I have power to the coil and I’ve checked many other connections and all seem to be powered correctly.
Everything else seems to be working perfectly… it just won’t fire.
Any ideas?