So I set off this past weekend to replace a torn rear inner CV joint on my 2012 Sportsman.
This is my first real repair job on this quad and everything started off fine…
I removed the wheel, brake, hub assembly and pulled the axle. I cut the boot off and separated the joint to clean out all the old oil. However I can not for the life of me figure out how to remove the inner race off the shaft.
The 2012 does not seem to have the same retaining ring as shown in http://www.polarisatvforums.com/foru…le-photos.html
Pictures of my axle included below…
So my question is how do I get the inner race off the shaft?
I would also like to know what replacement boots everyone is using?
It doesn’t look like the all balls boot I bought will fit (19-5006 All Balls Racing)
Thanks in advance,